|
|
 |
ONESuit® TEC/ONESuit® Flash
Description of Materials
ONESuit® TEC and ONESuit® Flash use only materials that have passed the most rigorous testing.
Garment Material
Garment barrier fabric for ONESuit® TEC is Challenge® NXT. Garment barrier fabric for ONESuit® Flash is Challenge® NXT-F. They are manufactured using proprietary fluoropolymer films produced by Saint-Gobain Performance Plastics, which are then laminated to aramid substrates.
Visor Material
The ONESuit® TEC visor is constructed of two layers, primary (inner) and secondary (outer). The primary visor is made of 10-mil FEP and provides full chemical/biological agent protection. The secondary visor is made of either clear or tinted 20-mil flexible PVC that attaches to the suit using nickel-plated snap fasteners and provides burst and tear-resistant properties. The ONESuit® Flash visor includes ONESuit® TEC visor construction plus an additional layer of PFA film to shield the PVC during flash fire exposure.
Gloves
ONEGlove® Hazmat, also manufactured by Saint-Gobain Performance Plastics, is an outstanding protective glove featuring single-piece construction and excellent dexterity, and comes standard with ONESuit® TEC and ONESuit® Flash.
Closure
The closure consists of a PVC-coated, vapor-tight zipper with garment material splash flaps that seal using hook-and-loop fastener strips. The zipper is installed for front entry; a 48-inch opening is created when the zipper is open.
Attachments
All garment seams are stitchless. They are produced by heat welding, and then covered on both sides with fluoropolymer film. The visor seam is heat-welded directly to the garment material. Gloves are attached using a ring and clamp assembly. The zipper is attached using thermoplastic adhesive film.
Exhaust Valves
The suits are equipped with two exhaust valves, manufactured by Saint-Gobain Performance Plastics; they are attached to the suits using a plastic nut, two rubber washers and one metal washer. The valve body is made from impact-resistant plastic, and the diaphragm is made from silicone rubber. The valves are covered by flaps made from garment material.
Pass-thrus
The suits are available with optional SCBA pass-thru assemblies installed upon request when ordering. These pass-thru assemblies accommodate the following SCBA manufacturers:
· Dräger
· Interspiro
· ISI
· MSA
· Survivair
· Scott
Refer to the manufacturer's instructions for information on a specific pass-thru.
Protective Helmet
The hoods of these suits are designed to be worn with an ANSI-style hard hat.
Boots
As an NPFA 1991 certified ensemble, ONESuit® TEC is to be worn with either Onguard Hazmax® protective boots (part # 87012, sizes 6-15) or Tingley HazProof® protective boots (part# 82330, 82331, sizes 7-13). The boots are worn over integral booties that are made of the garment material and connected directly to the suit. ONESuit® Flash is to be worn with Tingley HazProof® protective boots only. |
|
Contact us for more information or contact Customer Service: In the US: 1 800-451-6101
International:
+1 603-424-9000
Available ONESuit® TEC/ONESuit® Flash sizes.
Warranty information
ONESuit® Flash
|
